Re: [openss7] Problems

[Chuck Winters <cwinters@atl.lmco.com>]

Thanks Brian,
	I'll give it a shot today at lunch.

Chuck
"Brian F. G. Bidulock" wrote:
> 
> Chuck,
> 
> The only time I get wierd problems like this is when I change
> configuration defines and then simply do a make.  You will find
> it easier when you make configuration changes (e.g. CONFIG_SCTP_ )
> that it is a good idea to do:
> 
>         make clean
>         make depend
>         make install
>         make modules
>         make modules_install
> 
> One of the reasons for this is that the sizes of some things
> change in the kernel depending on configuration defines which
> are then applied in the module.  If you get the kernel and
> module out of sync you will get this problem.  Just rebuild the
> whole kernel from clean to be safe.  I'm sure it will clear
> up your problem.
> 
> --Brian
> 
> Chuck Winters wrote:                   Wed, 06 Jun 2001 18:18:58
> 
> [snip]
> > sctp_rtt_calc: ensure(time < jiffies) failed at sctp_input.c +132
> > sctp_rcv_init_ack: unless(!cb->daddr) failed at sctp_input.c +2066
> > sctp_rtt_calc: ensure(time < jiffies) failed at sctp_input.c +132
> > sctp_rcv_cookie_ack: unless(!cb->daddr) failed at sctp_input.c +2136
> [snip]
> 
> [snip]
> > sctp_rtt_calc: ensure(time < jiffies) failed at sctp_input.c +132
> > sctp_rcv_shutdown_ack: unless(!cb->daddr) failed at sctp_input.c +2265
> [snip]
> 
> --
> Brian F. G. Bidulock    ¦ The reasonable man adapts himself to the ¦
> bidulock@openss7.org    ¦ world; the unreasonable one persists in  ¦
> http://www.openss7.org/ ¦ trying  to adapt the  world  to himself. ¦
>                         ¦ Therefore  all  progress  depends on the ¦
>                         ¦ unreasonable man. -- George Bernard Shaw ¦

--
Chuck Winters                            | Email:  cwinters@atl.lmco.com
Distributed Processing Laboratory        | Phone:  856-338-3987
Lockheed Martin Advanced Technology Labs |
1 Federal St - A&E-3W                    |
Camden, NJ 08102                         |